Cisco SPA-122 ATA – Bridge Mode | AT&T Office@Hand
Article # 4741

How do I set up my Linksys SPA-122 ATA device on bridge mode?

How to set the Cisco SPA-122 ATA on Bridge mode

1. Get the IP address of your Linksys SPA-122 ATA device.
   • Plug in an analog phone to the Phone 1 or Phone 2 port.
   • Dial **** (four asterisks) and you will hear the Cisco Configuration Menu.
   • Dial 110# to obtain the IP address of your Linksys ATA.
2. Access the Cisco SPA-122’s Graphical User Interface (GUI).
   • Make sure that the Cisco SPA-122 is connected to the same network with your computer.
   • Open a browser on your computer, then enter the IP address in the address bar. This should open up the configuration window.
     Note: If you cannot access the configuration window, do the following:
   • Check if the you entered the correct IP address.
   • Plug your PC or laptop directly into the ethernet port of the ATA and type in the IP address.
   • Dial **** from the phone connected to your ATA to go back to the Cisco Configuration Menu, then dial 7932# . Dial 1 to turn on the web interface.
3. Enter the Username and Password on the Cisco SPA-122’s GUI.
   The default username is either admin or cisco. The default password is either blank, admin, or cisco. If you are not able to access the GUI, the device is most likely locked.
4. Set up device on bridge mode
   • Click the Network Setup tab.
   • Under the Basic Setup menu, click Network Service.
   • Under Network Service option, select the Bridge option in the drop down menu.
   • Click the Submit button to save the changes.

Key Words: bridge mode, spa-122 ata device, printer function on fax machine not working, ethernet port on ATA not working, no internet connection on the ATA device ethernet port

Was this page helpful? Yes No